TechnicalDebugging CIFS / samba on Windows

  

Press Ctrl+Enter to quickly submit your post
Quick Reply  
 
 
  
 From:  ANT_THOMAS   19 Jun 2016 21:43 
 To:  Peter (BOUGHTONP)       41 of 52 
41764.41 In reply to 41764.35 
I've actually done what you're doing years ago and I was able to use a more conventional network setup.

Probably easier using static IPs.

I had a small access point in client mode attached to the network via a cable and then wireless to the phone. This meant whenever the tethering was enabled the network got Internet access. Meant only a single wifi connection to the phone to get everything online.
0/0
 Reply   Quote More 

 From:  graphitone   19 Jun 2016 22:32 
 To:  Peter (BOUGHTONP)       42 of 52 
41764.42 In reply to 41764.40 
 :-O

 :-O~~~


images?q=tbn:8nj2HfmLhyV7yM:b
Drawings n' that
0/0
 Reply   Quote More 

 From:  patch   20 Jun 2016 06:36 
 To:  graphitone      43 of 52 
41764.43 In reply to 41764.37 
APIPA uses a /16 mask by default, so that's no biggy. If you can ping and ssh, then you know the connectivity is there, so it's either something in the PCs network adapter, or the NAS itself. Perhaps try deleting the NIC from the PC and then adding it again after a reboot. That might (might!) set it up with the default settings.
0/0
 Reply   Quote More 

 From:  graphitone   20 Jun 2016 10:35 
 To:  patch     Peter (BOUGHTONP)       44 of 52 
41764.44 In reply to 41764.43 
Aye, it's usable o' course, just unusual to see it - it always makes me think that the host has lost connectivity, but if PB's NAS is on the same range then all's ok.

Does the PC just have the one NIC?


images?q=tbn:8nj2HfmLhyV7yM:b
Drawings n' that
0/0
 Reply   Quote More 

 From:  Peter (BOUGHTONP)    20 Jun 2016 19:47 
 To:  patch      45 of 52 
41764.45 In reply to 41764.43 
"try deleting the NIC"

Do you mean go into Device Manager, Network adapters, and uninstall the relevant option - or something else?

 
0/0
 Reply   Quote More 

 From:  patch   21 Jun 2016 06:21 
 To:  Peter (BOUGHTONP)       46 of 52 
41764.46 In reply to 41764.45 
That's the one. No idea whether it will work, but it's worth a shot. The worst that happens is a full re-install, and it's probably about time you did that anyway.
0/0
 Reply   Quote More 

 From:  Peter (BOUGHTONP)    21 Jun 2016 21:45 
 To:  patch      47 of 52 
41764.47 In reply to 41764.46 
A full re-install may happen if hell freezes over, but not before.

I did it without re-starting yesterday and got a new 169 IP address, but no luck with the shares.

At some point I might have a go at inspecting packets with Wireshark to see what's actually going on, but for the time being I'll make do with FTP. :(

 
0/0
 Reply   Quote More 

 From:  ANT_THOMAS   21 Jun 2016 22:15 
 To:  Peter (BOUGHTONP)       48 of 52 
41764.48 In reply to 41764.47 
NFS?
0/0
 Reply   Quote More 

 From:  graphitone   21 Jun 2016 22:30 
 To:  Peter (BOUGHTONP)       49 of 52 
41764.49 In reply to 41764.47 
<pointing out the bleedin' obvious>

Are you sure the Windows box hasn't been assigned the same IP as the NAS?

 


images?q=tbn:8nj2HfmLhyV7yM:b
Drawings n' that
0/0
 Reply   Quote More 

 From:  Peter (BOUGHTONP)    21 Jun 2016 23:33 
 To:  ANT_THOMAS      50 of 52 
41764.50 In reply to 41764.48 
That requires me to determine why my "Turn Windows features on or off" list is blank, of which there's a variety of possible causes/solutions and it's not the common ones. :(

(Or locate a third-party client, but a quick check of the options didn't uncover anything acceptable; everyone recommends the Microsoft one.)

 
0/0
 Reply   Quote More 

 From:  ANT_THOMAS   21 Jun 2016 23:44 
 To:  Peter (BOUGHTONP)       51 of 52 
41764.51 In reply to 41764.50 
Sounds like hell has just frozen over.
0/0
 Reply   Quote More 

 From:  Ken (SHIELDSIT)   3 Jul 2016 19:07 
 To:  Peter (BOUGHTONP)       52 of 52 
41764.52 
Doesn't Windows assign a 169 address when it can't actually get a "good" address from DHCP?  I think you really need to use a different IP range.

Another thing, did you say you're using a wireless adapter for internet and a wired adapter to only access the NAS?  If that's the case, I've had times where the adapters come up in the wrong order and one doesn't work.  I would disable the wireless adapter and try to access the NAS.  What happens is Windows looks for the NAS over the wireless adapter and of course it won't find it there.
------------------------------------------------------------------------
"If you don't like donut, then leave it alone. Nobody force you to eat it."
0/0
 Reply   Quote More 

Reply to All    
 

1–20  21–40  41–52

Rate my interest:

Adjust text size : Smaller 10 Larger

Beehive Forum 1.5.2 |  FAQ |  Docs |  Support |  Donate! ©2002 - 2024 Project Beehive Forum

Forum Stats